This is an old revision of the document!

Metric From C3D Parameter

The metric command Metric from C3D Parameter is used to copy the values of a c3d parameter to a metric signal.

Metric_From_C3D_Parameter
/METRIC_NAME=
/PARAMETER_GROUP=
/PARAMETER_NAME=
;

The following table shows the command parameters seen above and their descriptions:

METRIC_NAME	The name of the result signal
PARAMETER_GROUP	Specify the group that the parameter is in
PARAMETER_NAME	The name of the original parameter

Example

Create a metric value of the C3D point rate.

Metric_From_C3D_Parameter
/METRIC_NAME=POINT_RATE
/PARAMETER_GROUP=POINT
/PARAMETER_NAME=RATE
;