Merge Aurora Files

The Merge Aurora Files command merges a set of NDI Aurora files into a Visual3D ASCII file.

The command can be found in the Pipeline Workshop within the File Open/Import folder as so:

Merge_Aurora_Files
! /INPUT_FILE_NAMES=
! /OUTPUT_FILE_NAME=
! /FRAME_RATE=1000
! /UNITS=cm
! /SET_PROMPT=Open Aurora files
;

The following table shows the command parameters seen above and their descriptions:

Parameter	Description
! /INPUT_FILE_NAME=	Name of input file
! /OUTPUT_FILE_NAME=	Name of file to be created
! /FRAME_RATE=	Frame rate for both files
! /UNITS=	Units to be used for file data
! /SET_PROMPT=	Optional prompt message shown if no input file is selected. Defaults to 'Open Aurora Files'.

The following code can be used to prompt the user to select an Aurora file with a frame rate of 540 fps and units of meters:

Merge_Aurora_Files
! /INPUT_FILE_NAMES=
/OUTPUT_FILE_NAME=OUTPUT_TEST
/FRAME_RATE=540
/UNITS=m
/SET_PROMPT=Open Aurora files
;

Wildcards (*) can be used for the INPUT_FILE_NAMES, for example:

/INPUT_FILE_NAMES=*input_test*

Wiki Documentation Site