Wiki Documentation Site

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Setup Checklist ======

==== Before Patient's Arrival ====

{{:Checkbox.jpg}} **Turn on ALL systems**

{{:Checkbox.jpg}} **Verify Position and Orientation of cameras**

Verify the position and orientation of Motion Capture Cameras
Verify the position and orientation of Force Platforms
Verify the position and orientation of Force Structures
Verify the position and orientation of Obstacles or Environment objects
{{:Checkbox.jpg}} **Perform System Calibration**

Perform static and/or dynamic calibrations of data collection devices
Verify results against the standards developed/referenced by your laboratory
{{:Checkbox.jpg}} **Verify the protocol being used for the session**

Verify the experimental protocol for the current data collection session
{{:Checkbox.jpg}} **Set appropriate system settings**

As per experimental protocol, set and verify system settings
e.g. sampling rates (synchronise), marker thresholds, ranges, triggers etc.
{{:Checkbox.jpg}} **Perform CalTester test**

Perform Caltester test at a minimum of 2 locations on each force platform
Verify against prior laboratory results
{{:Checkbox.jpg}} **Prepare necessary markers and supplies**

==== Patient's Arrival ====

{{:Checkbox.jpg}} **Obtain informed consent**

{{:Checkbox.jpg}} **Record subject details**

Insure that there are no contraindications for the patient completing the data collection
This may include data collection done via questionnaires or measurements
If data collection includes patient questionnaires check to make sure that they have been completed correctly
{{:Checkbox.jpg}} **Apply markers/IMUs/EMGs as per experimental protocol**

Take a set of digital pictures of the subject for post-hoc review of the marker placement.
{{:Checkbox.jpg}} **Record static calibration trial**

Ensure all markers are visible
{{:Checkbox.jpg}} **Verify recorded marker set**

Verify recorded marker set by launching Visual3D, creating model, and applying model template appropriate for the protocol
{{:Checkbox.jpg}} **Remove anatomical markers**

If necessary, remove anatomical markers not needed for tracking in motion trials
{{:Checkbox.jpg}} **Set the software system to broadcast the data**

Each manufacturer has their own method of turning on the broadcasting option in their software
Check your software/hardware system's user's manual for more information
==== After Patient Leaves ====

{{:Checkbox.jpg}} **Clean up work station**

{{:Checkbox.jpg}} **Save data as appropriate**