HAS-Motion Software Documentation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Troubleshooting ======

===== Overview =====

Listed bellow are the solutions to common problems that have been reported to the HAS-Motion support team. For step-by-step instructions on how to use the various features available in Inspect3D visit our [[other:inspect3d:tutorials:inspect3d_tutorials_overview|Inspect3D tutorials page]]. 


===== Working Data =====

=== All Grouped Data ===

All data/workspaces that were queried, regardless of what is plotted.

=== All Plotted Groups ===

Only perform work on the groups that are plotted on all plots. Work can be performed on:

  * All workspaces for those groups (regardless on if they are plotted or not)
  * Plotted Workspaces (works on entire workspace, even if only one trace/C3D is plotted)

== All Workspaces ==

Only perform work on the groups that are plotted in the active plot.

  * All workspaces for those groups (regardless on if they are plotted or not)
  * Plotted Workspaces (only works on the plotted data, so if only one trace/C3D is plotted, that is what will be used)

=== All Highlighted Data ===

Only data that is highlighted

===== Graph is missing data =====

If you plot data and there are empty data points, you may end up with a straight line at -9999999:

{{:DataMissingGraph.png}}

Most calculations (mean, standard deviation, etc) will handle empty data points without an issue, so you can choose not to plot data not found:

  * In the [[Other:Inspect3D:Documentation:Dialogs:Load_Library_Dialogue#Plotting_options|Options Dialogue]]
  * Uncheck **"Show data not found"**
  * Click **"Refresh Plot"**

You can also choose to exclude this data by selecting this data, right clicking -> Exclude -> Exclude trace (raw data).

{{:AdjustedDataMissingGraph.png}}

**NOTE:** Most calculations handle data not found, however, the input to PCA should not contain any missing data points.

===== Show Video dialogue is missing the video display =====

If you are using Inspect3D on a virtual machine (such as Parallels) and you open the [[Other:Inspect3D:Documentation:Dialogs:ToolBar#Show_Video|Show Video dialogue]] will not be able to see the video display. This is a known limitation of the virtual machine setup. The Video Dialogue will look like the dialogue displayed below.

{{:I3DVideoDialogue.png}}