Differences

This shows you the differences between two versions of the page.

--- visual3d:overview:testing_setup_checklist [2024/06/19 12:54] – sgranger
+++ visual3d:overview:testing_setup_checklist [2024/07/12 13:31] (current) – removed sgranger
@@ Line 1: / Line 1: @@
-when completing process oriented tasks, checklists are important part of the process. a thorough explanation of the benefits of checklists can be fount in [[http://gawande.com/the-checklist-manifesto|the checklist manifesto]]
-there are many crucial steps in collecting "routine" motion capture data.
-the following checklist is a starting point from which motion capture laboratories can build their own.
-we encourage users to contribute to this list by sending additional tasks to support@c-motion.com
-===== before patient's arrival =====
-====  turn on all systems ====
-====  verify position and orientation ====
-verify the position and orientation of motion capture cameras
-verify the position and orientation of force platforms
-verify the position and orientation of force structures
-verify the position and orientation of obstacles or environment objects
-====  perform system calibration ====
-perform static and/or dynamic calibrations of data collection devices
-verify results against the standards developed/referenced by your laboratory
-====  verify the protocol being used for the session ====
-verify the experimental protocol for the current data collection session
-====  set appropriate system settings ====
-as per experimental protocol, set and verify system settings
-e.g. sampling rates (synchronise), marker thresholds, ranges, triggers etc.
-====  zero force plates and perform caltester test ====
-perform caltester test at a minimum of 2 locations on each force platform
-verify against prior laboratory results
-====  prepare necessary markers and supplies ====
-===== patient's arrival =====
-====  obtain informed consent ====
-====  record subject details ====
-insure that there are no contraindications for the patient completing the data collection
-this may include data collection done via questionnaires or measurements
-if data collection includes patient questionnaires check to make sure that they have been completed correctly
-====  apply markers as per experimental protocol ====
-take a set of digital pictures of the subject for post-hoc review of the marker placement.
-====  record static calibration trial ====
-ensure all markers are visible
-====  verify recorded marker set ====
-verify recorded marker set by launching visual3d, creating model, and applying model template appropriate for the protocol
-====  remove anatomical markers ====
-if necessary, remove anatomical markers not needed for tracking in motion trials
-====  verify tracking using real time ====
-if you switch to the real time mode in visual3d, you can verify that the tracking markers assigned to each segment are appropriate, and that the force vectors make intuitive sense
-====  record dynamic trials ====
-====  verify force platform assignments ====
-load data into visual3d, assign movement trials to model, and verify force platform assignments
-remove assignments to partial force contacts
-remove assignments when two segments are in contact with the same platform.
-====  execute pipeline for creating event labels. ====
-verify that these event labels make intuitive sense. if not, data collection should be repeated
-===== after patient leaves =====
-====  clean up work station ====
-====  execute pipeline for processing ====
-====  load report template ====
-====  verify the report. ====