visual3d:documentation:pipeline:signal_commands:rectify
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| visual3d:documentation:pipeline:signal_commands:rectify [2025/12/15 18:56] – [Notes] wikisysop | visual3d:documentation:pipeline:signal_commands:rectify [2026/01/09 15:10] (current) – wikisysop | ||
|---|---|---|---|
| Line 27: | Line 27: | ||
| ====Command Parameters==== | ====Command Parameters==== | ||
| The parameters that can be used to control the command are as follows: | The parameters that can be used to control the command are as follows: | ||
| - | |**Signal Types**|The type of signal to be evaluated| | + | |**Signal Types**|The type of signal to be rectified| |
| - | |**Signal Folder**|The name of the signal to be evaluated| | + | |**Signal Folder**|The name of the signal to be rectified| |
| |**Signal Names**|The name of the signal folder| | |**Signal Names**|The name of the signal folder| | ||
| |**Result Types**|The type of the resulting signal| | |**Result Types**|The type of the resulting signal| | ||
visual3d/documentation/pipeline/signal_commands/rectify.1765824994.txt.gz · Last modified: by wikisysop