visual3d:documentation:pipeline:pipeline_commands:set_pipeline_parameter_to_data_value
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| visual3d:documentation:pipeline:pipeline_commands:set_pipeline_parameter_to_data_value [2026/06/19 17:32] – [Examples] wikisysop | visual3d:documentation:pipeline:pipeline_commands:set_pipeline_parameter_to_data_value [2026/06/19 18:04] (current) – wikisysop | ||
|---|---|---|---|
| Line 33: | Line 33: | ||
| ===Simple example=== | ===Simple example=== | ||
| - | Get the Participant ID from PARAMETERS: | + | Create a parameter called SUBJECT_ID based on subject names stored in PARAMETERS: |
| < | < | ||
| Line 47: | Line 47: | ||
| ===Complex example=== | ===Complex example=== | ||
| + | Example of EMG data processing using **Set_Parameter_Pipeline_To_Data_Value** to get the analog sampling which was used to determine the number of frames of the moving RMS window. | ||
| < | < | ||
| File_New | File_New | ||
visual3d/documentation/pipeline/pipeline_commands/set_pipeline_parameter_to_data_value.1781890346.txt.gz · Last modified: by wikisysop