visual3d:documentation:pipeline:pipeline_commands:prompt_for_multiple_pipeline_parameter_values
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| visual3d:documentation:pipeline:pipeline_commands:prompt_for_multiple_pipeline_parameter_values [2025/03/18 16:47] – wikisysop | visual3d:documentation:pipeline:pipeline_commands:prompt_for_multiple_pipeline_parameter_values [2025/03/18 16:47] (current) – wikisysop | ||
|---|---|---|---|
| Line 40: | Line 40: | ||
| - | |\\ If the DEFAULT_VALUE_COUNT parameter is set to 1 (this is the default value), each pipeline parameter can only be set to one value.\\ Using the DEFAULT_VALUE_COUNT parameter command (shown on the right) allows the user to set a pipeline parameter to a list of values. An example of the prompt using this parameter is shown below.|{{: | + | |\\ If the DEFAULT_VALUE_COUNT parameter is set to 1 (this is the default value), each pipeline parameter can only be set to one value.\\ Using the DEFAULT_VALUE_COUNT parameter command (shown on the right) allows the user to set a pipeline parameter to a list of values.\\ An example of the prompt using this parameter is shown below.|{{: |
| < | < | ||
| Prompt_For_Multiple_Pipeline_Parameter_Values | Prompt_For_Multiple_Pipeline_Parameter_Values | ||
visual3d/documentation/pipeline/pipeline_commands/prompt_for_multiple_pipeline_parameter_values.1742316455.txt.gz · Last modified: 2025/03/18 16:47 by wikisysop