visual3d:documentation:pipeline:other_commands:set_model_pose_algorithm
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| visual3d:documentation:pipeline:other_commands:set_model_pose_algorithm [2026/06/17 18:43] – wikisysop | visual3d:documentation:pipeline:other_commands:set_model_pose_algorithm [2026/06/17 18:58] (current) – [Command Parameters] wikisysop | ||
|---|---|---|---|
| Line 29: | Line 29: | ||
| |ALGORITHM |Pose Algorithm to set 6DOF is default or can change to Inverse Kinematics| | |ALGORITHM |Pose Algorithm to set 6DOF is default or can change to Inverse Kinematics| | ||
| |OPTIMIZER |Set optimizer to one of QUASI_NEWTON, | |OPTIMIZER |Set optimizer to one of QUASI_NEWTON, | ||
| - | |FIT_CALIBRATION_FILE |...| | + | |FIT_CALIBRATION_FILE | TRUE or FALSE fit the calibration trial| |
| |START_WITH_SIMULATED_ANNEALING | TRUE FALSE to generate an initial solution before optimization using simulated annealing| | |START_WITH_SIMULATED_ANNEALING | TRUE FALSE to generate an initial solution before optimization using simulated annealing| | ||
| |F_TOLERANCE | Convergence tolerance for the objective function. Default e-12 | | |F_TOLERANCE | Convergence tolerance for the objective function. Default e-12 | | ||
visual3d/documentation/pipeline/other_commands/set_model_pose_algorithm.1781721781.txt.gz · Last modified: by wikisysop