visual3d:documentation:pipeline:other_commands:set_laboratory_coordinate_system
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| visual3d:documentation:pipeline:other_commands:set_laboratory_coordinate_system [2024/06/19 14:02] – created sgranger | visual3d:documentation:pipeline:other_commands:set_laboratory_coordinate_system [2024/11/22 18:25] (current) – wikisysop | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Set Laboratory Coordinate System ====== | ||
| + | |||
| This command will set the laboratory coordinate system | This command will set the laboratory coordinate system | ||
| - | **Set_Laboratory_Coordinate_System** | + | < |
| + | Set_Laboratory_Coordinate_System | ||
| / | / | ||
| / | / | ||
| - | **;** | + | ; |
| + | </ | ||
| The user is allowed only to select two of the principal axes of the laboratory coordinate system because Visual3D only permits a right handed coordinate system. | The user is allowed only to select two of the principal axes of the laboratory coordinate system because Visual3D only permits a right handed coordinate system. | ||
visual3d/documentation/pipeline/other_commands/set_laboratory_coordinate_system.1718805753.txt.gz · Last modified: 2024/06/19 14:02 by sgranger