visual3d:documentation:pipeline:other_commands:set_laboratory_coordinate_system
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| visual3d:documentation:pipeline:other_commands:set_laboratory_coordinate_system [2024/06/17 18:22] – created sgranger | visual3d:documentation:pipeline:other_commands:set_laboratory_coordinate_system [2024/11/22 18:25] (current) – wikisysop | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Set Laboratory Coordinate System ====== | ||
| + | |||
| This command will set the laboratory coordinate system | This command will set the laboratory coordinate system | ||
| - | **Set_Laboratory_Coordinate_System** | + | < |
| + | Set_Laboratory_Coordinate_System | ||
| / | / | ||
| / | / | ||
| - | **;** | + | ; |
| + | </ | ||
| The user is allowed only to select two of the principal axes of the laboratory coordinate system because Visual3D only permits a right handed coordinate system. | The user is allowed only to select two of the principal axes of the laboratory coordinate system because Visual3D only permits a right handed coordinate system. | ||
| Setting the Laboratory Coordinate System (LCS) in Visual3D has many consequences. First, the LCS defines the coordinate system in which the Motion Capture data was recorded. Second, the LCS defines the direction of gravity. Third, the LCS defines the default Segment Coordinate System when a segment is created in Model Builder. | Setting the Laboratory Coordinate System (LCS) in Visual3D has many consequences. First, the LCS defines the coordinate system in which the Motion Capture data was recorded. Second, the LCS defines the direction of gravity. Third, the LCS defines the default Segment Coordinate System when a segment is created in Model Builder. | ||
| - | |||
| - | |||
visual3d/documentation/pipeline/other_commands/set_laboratory_coordinate_system.1718648520.txt.gz · Last modified: 2024/06/17 18:22 by sgranger