visual3d:documentation:pipeline:model_commands:get_vicon_model_metric
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| visual3d:documentation:pipeline:model_commands:get_vicon_model_metric [2026/06/11 19:06] – [Pipeline Command] wikisysop | visual3d:documentation:pipeline:model_commands:get_vicon_model_metric [2026/06/11 19:07] (current) – [Pipeline Command] wikisysop | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| ===== Pipeline Command ===== | ===== Pipeline Command ===== | ||
| + | |||
| + | The command can be found in the **Pipeline Workshop** under **Model Building** as so | ||
| < | < | ||
| Line 15: | Line 17: | ||
| </ | </ | ||
| + | |||
| + | ====Command Parameters==== | ||
| + | |||
| + | The following table shows the command parameters seen above and their descriptions: | ||
| |CALIBRATION_FILE| The Link Model in which the metrics will be stored if empty or =*, the current link model is used| | |CALIBRATION_FILE| The Link Model in which the metrics will be stored if empty or =*, the current link model is used| | ||
| Line 23: | Line 29: | ||
| - | |||
| - | |||
| - | If Metric_Values is populated, this is the default value of Metric_Names and is used if Metric_Names does not exist in the .MP file. | ||
| ===== Example ===== | ===== Example ===== | ||
visual3d/documentation/pipeline/model_commands/get_vicon_model_metric.1781204797.txt.gz · Last modified: by wikisysop