Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:pipeline:model_commands:add_functional_joint_landmark [2024/06/17 18:21] – created sgranger
+++ visual3d:documentation:pipeline:model_commands:add_functional_joint_landmark [2024/07/17 15:46] (current) – created sgranger
@@ Line 1: / Line 1: @@
+====== Add Functional Joint Landmark ======
 **This is a legacy command in Visual3D. Visual3D version 4.0 has a new interface for functional joints, and new way of specifying a functional joint landmark as part of the model template. This command should continue to work as originally implemented but it is recommended that you adopt the current approach**
@@ Line 8: / Line 6: @@
 **Schwartz MH, Rozumalski A** (2005) A new method for estimating joint parameters from motion data. Journal of Biomechanics, 38, 107-116
-[[Add_Functional_Joint_Landmark.png]]
+{{:Add_Functional_Joint_Landmark.png}}
 **Add_Functional_Joint_Landmark**
@@ Line 40: / Line 38: @@
   * If no Reference Segment is specified, the landmark will be created relative to the first three REFERENCE MARKERS (e.g. a Technical Coordinate System will be created from these markers). If more than 3 REFERENCE MARKERS are specified, Visual3D will use all REFERENCE MARKERS to track the Technical Coordinate System.
-==== NOTES ====
+=== NOTES ===
 The motion trials being used to identify the functional joint landmark must be [[Visual3D:Documentation:Pipeline:Model_Commands:Assign_Model_File|assigned]] to the static calibration trial.
@@ Line 54: / Line 52: @@
 If OTHER_SEGMENT_NAME is balcn, SIGNAL_TYPES, SIGNAL_NAMES, SIGNAL_FOLDER must be specified.