visual3d:documentation:pipeline:metric_commands:metric_vector_between_events
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| visual3d:documentation:pipeline:metric_commands:metric_vector_between_events [2024/06/19 14:01] – created sgranger | visual3d:documentation:pipeline:metric_commands:metric_vector_between_events [2024/07/17 15:46] (current) – created sgranger | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Metric Vector Between Events ====== | ||
| + | |||
| This command creates a metric vector of a signal(s) value between a start and an end event. The command and it's parameters are found below: | This command creates a metric vector of a signal(s) value between a start and an end event. The command and it's parameters are found below: | ||
| Line 17: | Line 19: | ||
| The command can be edited in the text editor of the pipeline workshop or can be edited from a dialog. The dialog that pops up when pipeline selection is edited by double clicking with the left mouse button. The example below shows the dialog. | The command can be edited in the text editor of the pipeline workshop or can be edited from a dialog. The dialog that pops up when pipeline selection is edited by double clicking with the left mouse button. The example below shows the dialog. | ||
| - | ===== Example: Stride Length Vector for Gait ===== | + | ==== Example: Stride Length Vector for Gait ==== |
| The dialog below contains the values for creating the Stride Length vector on the right side during gait. | The dialog below contains the values for creating the Stride Length vector on the right side during gait. | ||
| - | {{MetricVectorBetweenEventsDlg.png}} | + | {{:MetricVectorBetweenEventsDlg.png}} |
| The command looks like this in the text editor: | The command looks like this in the text editor: | ||
| Line 49: | Line 51: | ||
| - | ===== Example: Stride Length Vector for Throwing | + | ==== Example: Stride Length Vector for Throwing ==== |
| A stride length vector (or scalar) can also be calculated in throwing. Events are created that define the particular phases of the throwing motion. Below is an example of calculating a stride length between **Arm Cock Start** and **Lead Foot Contact**. | A stride length vector (or scalar) can also be calculated in throwing. Events are created that define the particular phases of the throwing motion. Below is an example of calculating a stride length between **Arm Cock Start** and **Lead Foot Contact**. | ||
| Line 72: | Line 74: | ||
| </ | </ | ||
| - | ===== Visual3D Versions supporting Subject Prefixes | + | ==== Visual3D Versions supporting Subject Prefixes ==== |
| NOTE: When using events in a command, the commands will iterate across subjects contained in the current workspace. As such, events and sequences listed as command parameters should NOT contain a prefix. As each subject is processed, the event range/ | NOTE: When using events in a command, the commands will iterate across subjects contained in the current workspace. As such, events and sequences listed as command parameters should NOT contain a prefix. As each subject is processed, the event range/ | ||
visual3d/documentation/pipeline/metric_commands/metric_vector_between_events.1718805694.txt.gz · Last modified: 2024/06/19 14:01 by sgranger