Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:pipeline:metric_commands:metric_golf_swing_plane [2024/07/17 15:23] – sgranger
+++ visual3d:documentation:pipeline:metric_commands:metric_golf_swing_plane [2024/09/12 18:57] (current) – wikisysop
@@ Line 5: / Line 5: @@
 The purpose of the event sequence is to allow the computation of different planes through the swing. For example, a plane during takeaway.
-**Metric_Golf_Swing_Plane**
+<code>
-/SIGNAL_TYPES=TARGET
+Metric_Golf_Swing_Plane
-SIGNAL_NAMES=CLUB
+/SIGNAL_TYPES=TARGET
+SIGNAL_NAMES=CLUB
 /SIGNAL_FOLDER=ORIGINAL
 /RESULT_NAME=STANCE_CLUB
@@ Line 13: / Line 14: @@
 /EVENT_SEQUENCE=TAKEAWAY+BACK
 ! /EXCLUDE_EVENTS=
-**;**
+;
+</code>
 or a plane at the beginning of the backswing.
-**Metric_Golf_Swing_Plane**
+<code>
+Metric_Golf_Swing_Plane
 /SIGNAL_TYPES=TARGET
 /SIGNAL_NAMES=CLUB
@@ Line 24: / Line 28: @@
 /EVENT_SEQUENCE=TOP+DOWN
 ! /EXCLUDE_EVENTS=
-**;**
+;
+</code>
 The dialog for this command is:
@@ Line 31: / Line 37: @@
 \\
 To display the two swing planes use the command Highlight_Golf_Features:
+<code>
-**Highlight_Golf_Features**
+Highlight_Golf_Features
 ! /CALIBRATION_FILE=
 ! /X_FACTOR=RPV::X+RTA::X
@@ Line 44: / Line 50: @@
 /HIGHLIGHT_STANCE_PLANE=TRUE
 /HIGHLIGHT_SWING_PLANE=TRUE
-**;**
+;
+</code>
 {{:GolfHighlightsDialog.jpg}}