Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:pipeline:force_commands:set_force_platform_threshold [2024/06/26 20:05] – removed sgranger
+++ visual3d:documentation:pipeline:force_commands:set_force_platform_threshold [2026/01/08 18:38] (current) – wikisysop
@@ Line 1: / Line 1: @@
+====== Set Force Platform Threshold ======
+This command is used to set a Force Threshold. Any force platform signal below this threshold will be set to zero. This can be used to account for noise or small variations in force.
+====Pipeline Command====
+The pipeline command for **Set Force Platform Threshold** can be found in the Pipeline Workshop within the **Force** folder as so:
+<code>
+Set_Force_Platform_Threshold
+! /THRESHOLD=
+! /SET_AS_DEFAULT=FALSE
+;
+</code>
+====Command Parameters====
+The following table shows the command parameters seen above and their descriptions:
+|**Threshold**| The minimum value under which signals will be set to 0|
+|**Set As Default**|True or False: Make this value the default value|
+====Example: Set Minimum Threshold to 50N====
+<code>
+Set_Force_Platform_Threshold
+/THRESHOLD=50
+! /CALTESTER_THRESHOLD=
+/SET_AS_DEFAULT=TRUE
+;
+</code>
+====Notes====
+This value may also be set manually by going to **Force -> [[Visual3D:Documentation:Kinematics_and_Kinetics:External_Forces:Force_Platforms#Minimum_Force|Modify Minimum Force Platform Value]]**
+If using this command in a pipeline script, do not forget to use the [[Visual3D:Documentation:Pipeline:File_Commands:Recalc|RECALC]] command (listed under [[Visual3D:Documentation:Pipeline:File_Commands:File_Management_Overview|File Management]] category in the pipeline workspace) to update force/kinetic signals.