Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:pipeline:file_commands:upsample_point_data_to_analog_rate [2024/06/14 17:26] – created sgranger
+++ visual3d:documentation:pipeline:file_commands:upsample_point_data_to_analog_rate [2024/11/20 20:58] (current) – Cleaned up towards Pipeline Command template. wikisysop
@@ Line 1: / Line 1: @@
-Upsamples the point data of a C3D file to match the analog rate using a cubic spline. (If there are no analog signals, the analog rate can be specified by adding the hidden parameter ANALOG_RATE).
+===== Upsample Point Data To Analog Rate =====
+This command upsamples the [[visual3d:documentation:c3d_signal_types:target_data_type|Point data]] of a [[visual3d:documentation:c3d_signal_types:c3d_format|C3D file]] to match the [[visual3d:documentation:c3d_signal_types:analog_data_type|ANALOG rate]] using a cubic spline.
+==== Pipeline Command ====
 <code>
 Upsample_Point_Data_To_Analog_Rate
@@ Line 6: / Line 9: @@
 </code>
-\\
+**Note**: This command has no parameters, but if there are no ANALOG signals in the C3D file then the analog rate can be specified by adding the hidden parameter ANALOG_RATE.
-[[Visual3D:Documentation:Pipeline:General_Information:Pipeline_Commands_Reference|Back to Pipeline Commands Reference]]
+==== See Also ====
+Go back to the [[Visual3D:Documentation:Pipeline:General_Information:Pipeline_Commands_Reference|Pipeline Commands Reference]].
-Retrieved from ""