visual3d:documentation:pipeline:event_commands:event_sequence_delete
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| visual3d:documentation:pipeline:event_commands:event_sequence_delete [2025/04/28 16:46] – [Notes] wikisysop | visual3d:documentation:pipeline:event_commands:event_sequence_delete [2025/04/28 19:05] (current) – wikisysop | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Event Sequence Delete ====== | ====== Event Sequence Delete ====== | ||
| - | =====Event Sequence Delete===== | + | =====Overview===== |
| - | + | ||
| - | ====Overview==== | + | |
| The `Event_Sequence_Delete` command **removes a previously defined event sequence** from the motion file. | The `Event_Sequence_Delete` command **removes a previously defined event sequence** from the motion file. | ||
| * Event sequences are often used to group event pairs (e.g., LHS to LTO) into meaningful motion phases. This command allows you to cleanly remove those sequences if no longer needed or if you’re regenerating them. | * Event sequences are often used to group event pairs (e.g., LHS to LTO) into meaningful motion phases. This command allows you to cleanly remove those sequences if no longer needed or if you’re regenerating them. | ||
| Line 9: | Line 7: | ||
| * A **requirement** is that the event sequence to be deleted must already exist, and its name must match exactly. | * A **requirement** is that the event sequence to be deleted must already exist, and its name must match exactly. | ||
| - | ====Pipeline Command==== | + | =====Pipeline Command===== |
| The pipeline command is shown below as seen in the Visual3D application. | The pipeline command is shown below as seen in the Visual3D application. | ||
| Line 19: | Line 17: | ||
| </ | </ | ||
| - | ====Command Parameters==== | + | =====Command Parameters===== |
| The following table shows the command parameters and descriptions. | The following table shows the command parameters and descriptions. | ||
| Line 26: | Line 24: | ||
| |**/ | |**/ | ||
| - | ====Dialog==== | + | =====Dialog===== |
| Due to the simplicity of this command, there is no dialog box and it can be edited within the text editor. | Due to the simplicity of this command, there is no dialog box and it can be edited within the text editor. | ||
| - | ====Examples==== | + | =====Examples===== |
| The following example shows the use of the Event_Sequence_Delete command in the Visual3D application, | The following example shows the use of the Event_Sequence_Delete command in the Visual3D application, | ||
| - | ===Example: Delete and Redefine Sequence==== | + | ====Example |
| The functionality of this command is very straightforward. Simply type in the name of the event sequence desired to be deleted. | The functionality of this command is very straightforward. Simply type in the name of the event sequence desired to be deleted. | ||
| Line 46: | Line 44: | ||
| Event_Define_Event_Sequence | Event_Define_Event_Sequence | ||
| / | / | ||
| - | / | + | / |
| / | / | ||
| / | / | ||
visual3d/documentation/pipeline/event_commands/event_sequence_delete.1745858804.txt.gz · Last modified: 2025/04/28 16:46 by wikisysop