Differences

This shows you the differences between two versions of the page.

--- visual3d:documentation:pipeline:event_commands:event_save_tpr_signal [2025/04/28 18:28] – wikisysop
+++ visual3d:documentation:pipeline:event_commands:event_save_tpr_signal [2025/04/29 14:02] (current) – [Dialog] wikisysop
@@ Line 49: / Line 49: @@
 {{:visual3d:documentation:pipeline:event_commands:tpr_signal_save_dlg.png?400|}}
-These options are reflected in the parameters table.
+  * **File Name**: The name of the output where the TPR signal will be saved.
+  * **Pattern File**: File with applied TPR used to generate events in new signal.
+  * **Display Short Filenames**: If checked, shows abbreviated versions of file names in dropdowns.
+  * **Pattern Type**: The type of signal which the TPR algorithm is applied to (ANALOG, LINK_MODEL_BASED, etc.)
+  * **Pattern Folder**: Folder name where the pattern signal is stored.
+  * **Pattern Signal Name**: Name of signal which has the TPR algorithm applied to it.
+  * **Pattern Event**: Event which TPR algorithm bases off of.
+  * **Event Instance**: Specifies which instance of the event to label.
+  * **Radius Samples**: Defines the width of the matching window around the event in samples.
 =====Examples=====
 The following example shows the use of Event_Save_TPR_Signal command in the Visual3D application.
@@ Line 74: / Line 82: @@
 </code>
-This can now be used as the pattern file when looking to specify right side events or apply LHS events to a file that does not have any yet.
+This can now be used as the pattern file when looking to specify right side events or apply LHS events to a file that does not have any yet. This file can be used via the [[visual3d:documentation:pipeline:event_commands:event_tpr_file|Event_TPR_File]] command.
-====Notes====