other:ior_gait:documentation:foot_collection
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
other:ior_gait:documentation:foot_collection [2024/07/12 13:27] – removed sgranger | other:ior_gait:documentation:foot_collection [2024/07/17 15:44] (current) – created sgranger | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Foot Collection ====== | ||
+ | |||
+ | \\ | ||
+ | |||
+ | |||
+ | ==== Introduction ==== | ||
+ | |||
+ | |Each lab has a different data collection protocol, however, there are some important data collection requirements to use the IORGait protocol.\\ \\ This section describes requirements such as the marker set specific to the foot analysis. The requirements for completing the gait analysis can be found [[Other: | ||
+ | |||
+ | \\ | ||
+ | |||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | ==== Lab Setup - Before the Patient Arrives ==== | ||
+ | |||
+ | 1. Calibrate you capture volume as recommended by your camera' | ||
+ | |||
+ | 2. Zero your force plates. | ||
+ | |||
+ | 3. Set up all materials that you will need for the capture including, but not limited to: at least 36 markers, with adhesives attached; scale; and measuring tape for height. The referring physician may request other measurements, | ||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | === Subject Setup - Marker Placement === | ||
+ | |||
+ | The anatomical location of each target is referenced to the description in the [[https:// | ||
+ | |||
+ | The FMB and SMB target locations are not described in the [[https:// | ||
+ | |||
+ | |\\ \\ \\ \\ **Marker Placement - Listed by from knees to toes**\\ |Marker Name|Description | ||
+ | |||
+ | === References === | ||
+ | |||
+ | - ↑ < | ||
+ | - ↑ < | ||
+ | |||
+ | |||
+ | \\ | ||
+ | |||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | ==== Data Collection ==== | ||
+ | |||
+ | === Static Trial === | ||
+ | |||
+ | During the static trial, the subject should: | ||
+ | |||
+ | 1. Stand stationary | ||
+ | 2. Feet on one or two of the force platforms | ||
+ | 3. Comfortable stance | ||
+ | 4. Feet shoulder width apart | ||
+ | 5. Arms out to so that markers are not occluded | ||
+ | During the static trial, the user should: | ||
+ | |||
+ | 1. Instruct the subject where to stand and in what posture | ||
+ | 2. Collect approximately a three second trial using the motion capture software while the subject is stationary | ||
+ | 3. Instruct the subject to relax | ||
+ | 4. Label the static trial to ensure all targets appear | ||
+ | If all targets have been placed on the subject, if not, collect a new static trial, or overwrite the original static trial | ||
+ | === Dynamic Gait Trials === | ||
+ | |||
+ | Collect dynamic trials: | ||
+ | |||
+ | 1. Have the patient start at one end of the capture volume and have them walk across the force plates at a self selected normal speed. | ||
+ | 2. Collect at least one good foot strike per gait trial. | ||
+ | [[Other: | ||
+ | 2. Make sure: | ||
+ | 1. No targets fall off the subject during data collection | ||
+ | 2. Targets do not become occluded due to clothing, etc. | ||
+ | To complete the IORgait analysis, at least two clean foot strikes (one right, one left) must be collected. However, the total number of trials collected is an individual lab decision. Many users collect at least five clean foot strikes for the left and five for the right. The amount of trials this requires may depend on the number of force platforms in your lab. | ||
+ | |||
+ | |||
other/ior_gait/documentation/foot_collection.1720790830.txt.gz · Last modified: 2024/07/12 13:27 by sgranger