Differences

This shows you the differences between two versions of the page.

--- other:dsx:calibratedsx:3d_calibration [2024/07/17 15:21] – sgranger
+++ other:dsx:calibratedsx:3d_calibration [2025/02/15 05:56] (current) – Cleaned up page and added backlink to widgets overview. wikisysop
@@ Line 5: / Line 5: @@
 {{:CalDSX_3DCalibrationWidget.png}}
+^ Parameter ^ Description ^
+| **Image Distance Allowance** | Used when calculating the 3D configuration parameters. It is the amount by which the source-to-image-plane distance is allowed to change from the user-specified value. The default value is 0.0.|
+| **Optimize Pixel Size** | Specifies whether or not to optimize the pixel size when calculating the 3D configuration parameters. The default value is false (box is unchecked). |
+| **Square Pixels** | Specifies whether or not to force the X and Y pixel sizes to be the same when distortion-correcting the X-ray images. The default value is true (box is checked).|
+| **Source To Image** | The distance between the X-ray source and the plane of the image intensifier or flat-panel detector. This distance should be measured carefully in millimeters during data collection, and entered into the subject file with [[Other:DSX:xManager:xManager_Overview|xManager]]. It can also be entered here if 3D calibration has not been performed yet. During 3D calibration, this distance will be optimized by the DLT algorithm if **Image Distance Allowance** is greater than zero, and its updated value will be shown here. |
+===== See Also =====
-  * **Image Distance Allowance** Used when calculating the 3D configuration parameters. It is the amount by which the source-to-image-plane distance is allowed to change from the user-specified value. The default value is 0.0.
+Go back to an overview of [[other:dsx:calibratedsx:calibratedsx_overview#widgets|CalibrateDSX's widgets]].
-  * **Optimize Pixel Size** Specifies whether or not to optimize the pixel size when calculating the 3D configuration parameters. The default value is false (box is unchecked).
-  * **Square Pixels** Specifies whether or not to force the X and Y pixel sizes to be the same when distortion-correcting the X-ray images. The default value is true (box is checked).
-  * **Source To Image** The distance between the X-ray source and the plane of the image intensifier or flat-panel detector. This distance should be measured carefully in millimeters during data collection, and entered into the subject file with [[Other:DSX:xManager:xManager_Overview|//xManager//]]. It can also be entered here if 3D calibration has not been performed yet. During 3D calibration, this distance will be optimized by the DLT algorithm if **Image Distance Allowance** is greater than zero, and its updated value will be shown here.