HAS-Motion Software Documentation

User Tools

Site Tools

You are here: Main Page » other » capture2d » Recording Data
other:capture2d:recording_data

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
other:capture2d:recording_data [2024/06/17 18:13] – created sgrangerother:capture2d:recording_data [2024/07/17 15:44] (current) – created sgranger
Line 1: Line 1:
 +====== Recording Data ======
 +
 Once the 'Start Recording' button is pressed, a countdown will begin (as indicated by the status bar at the bottom of the dialog), and then the data collection will start. Once the 'Start Recording' button is pressed, a countdown will begin (as indicated by the status bar at the bottom of the dialog), and then the data collection will start.
  
 When recording starts the status bar then indicates the progress of the recording and the number of frames recorded. When recording starts the status bar then indicates the progress of the recording and the number of frames recorded.
  
-[[Capture_trails.png]]+{{:Capture_trails.png}}
  
 In this figure the marker trails have been turned on. This is a useful feature when capturing the calibration trial, because it provides a quick overview of the coverage of the wand through the view of each camera. In this figure the marker trails have been turned on. This is a useful feature when capturing the calibration trial, because it provides a quick overview of the coverage of the wand through the view of each camera.
  
 In this example, camera 12 will likely not calibrate well because the wand has not covered a sufficient region of the viewer. In this example, camera 12 will likely not calibrate well because the wand has not covered a sufficient region of the viewer.
- 
- 
  
  
  
other/capture2d/recording_data.1718647983.txt.gz · Last modified: 2024/06/17 18:13 by sgranger