Differences

This shows you the differences between two versions of the page.

--- other:amass:tutorials:installation [2024/07/03 17:34] – created sgranger
+++ other:amass:tutorials:installation [2024/07/17 15:44] (current) – created sgranger
@@ Line 1: / Line 1: @@
-====== Installation_ ======
+====== Installation  ======
 \\
@@ Line 11: / Line 11: @@
 After you log in at [[https://www.c-motion.com|www.c-motion.com]], you will see a screen similar to this:\\
 \\
-{{Down1.jpg}}\\
+{{:Down1.jpg}}\\
 \\
@@ Line 41: / Line 41: @@
 ==== Visual3D ====
-**DOWNLOAD** and install Visual3D if appropriate. Instructions are [[Visual3D:Getting_Started|here]].
+**DOWNLOAD** and install Visual3D if appropriate. Instructions are [[Visual3D:Getting_Started:Getting_Started|here]].
 ==== Configure AMASS ====
@@ Line 52: / Line 52: @@
 //Note: AMASS starts and loads the last project it was working on. If there was no previous project, or it was moved, then the following screen appears.//
-{{a1.png}}
+{{:a1.png}}
 For a new installation, click “Create a Default Project”.
@@ Line 72: / Line 72: @@
   * ViewCen = Checked (to view centroids meaning to actually see the targets/markers)
-{{a3.png}}
+{{:a3.png}}
 === Calibrate Tab ===
@@ Line 83: / Line 83: @@
 Click **Browse…** and navigate to select the file you want. This file identifies your L-Frame and where the markers are located on it. The sample is for a NaturalPoint frame.
-{{a4.png}}
+{{:a4.png}}
 === Track Tab ===
@@ Line 93: / Line 93: @@
 This is not critical, since if you create a new calibration file (or run the tutorial) when you click an "Apply" button that will overwrite whatever is here.
-{{a5.png}}
+{{:a5.png}}
 === Identify Tab ===
@@ Line 102: / Line 102: @@
   * Link File = can be blank. It is unused now, but will be needed for the automatic tracking feature (coming soon)
-{{a6.png}}
+{{:a6.png}}
 \\