Differences

This shows you the differences between two versions of the page.

--- caltester:caltesterplus:tutorials:platform [2024/06/26 20:15] – created sgranger
+++ caltester:caltesterplus:tutorials:platform [2024/07/17 15:44] (current) – created sgranger
@@ Line 24: / Line 24: @@
 **1. Use the add button at the top right-hand side of the screen to load all of the .c3d files that you want to use to create a report from, and select them by highlighting them. For the sample data we will be using the files "TrialBack1.c3d" through to "TrialBack11.c3d".**
-{{PlatformTutorial1.png}}
+{{:PlatformTutorial1.png}}
 **2. Make sure that you are on the Platform tab at the bottom section of the screen.**\\
 (A) Check that you have selected the force platform number that corresponds to the force platform that the CalTester Rod was used on. If you are using the sample data it is FP 1.\\
@@ Line 33: / Line 33: @@
-{{PlatformTutorial2.png}}
+{{:PlatformTutorial2.png}}
 **3. Check the CalTester rod labels:**\\
 (A) If the CalTester rod is not already labeled click the Guess Combinations button.\\
 (B) Verify that the CalTester Rod has been appropriately labeled. The proper labeling for the sample data is shown below. The Save Combination as Default button can be used if this is a naming convention that you will be reusing.
-{{PlatformTutorial4.png}}
+{{:PlatformTutorial4.png}}
 **5. Check that the dimensions of the CalTester Rod are correct.**
 If you are using the sample data or the CalTester Rod manufactured by [[http://www.motion-labs.com/|Motion Lab Systems]] use the values that are specified below.
-If you have made your own rod you will need to enter the correct measurements. See [[CalTester:CalTesterPlus:Documentation:Overview#Report_Dimensions|here]] for more information.
+If you have made your own rod you will need to enter the correct measurements. See [[CalTester:CalTesterPlus:Documentation:CalTesterPlus_Doocumentation_Overview#Report_Dimensions|here]] for more information.
-{{PlatformTutorial5.png}}
+{{:PlatformTutorial5.png}}
 **6. Enter the size of your force platforms into the FP size tab.**\\
 (A) If not FP exists, click "Add New Force" to populate the list box\\
@@ Line 52: / Line 52: @@
 If you do not enter the size of your force platform, the C3D corners are used to estimate the size.
-{{PlatformTutorial7.png}}
+{{:PlatformTutorial7.png}}
 **6. Ensure the desired C3D trials are still selected, and the settings on the main tab are correct.**\\
 (A) **If the FP size was specified** , ensure the desired FP is selected in the drop down (FP1 in this tutorial).\\
-{{CalTester_FPC_FinalInputPage.png}}
+{{:CalTester_FPC_FinalInputPage.png}}
 **7. Click on the Go button at the bottom of the screen.**\\
-{{CalTester_Go.png}}
+{{:CalTester_Go.png}}
 **8. The program will ask you where you want to save the text file that has been created with the outputs.**\\
-{{PlatformTutorial8.png}}
+{{:PlatformTutorial8.png}}
 **9. The text file should contain a readout similar to what was produced below from the sample files.**\\